Grouper Set Up

Grouper Setup Video

TAKE YOUR BEACH EXPERIENCE TO A NEW LEVEL WITH THE GROUPER FLOAT KIT!

Pre-Order Now

Step 1 - Inflate Grouper Float

Charge the mini-pump and place the rubber nozzle onto the end of the air pump exit valve. Open the top part of the air valve cover on the float. Hold the rubber nozzle firmly up against the opening of the air valve. Press the power button on the pump twice to turn it one and fill the Grouper with air. DO NOT OVERFILL. The top part of the air valve has a one-way valve to simplify the filling process. To Deflate - remove the large lower air valve cover and let the air out. You can put light pressure on the float to speed the process but do not put too much pressure to avoid damaging the float.

Step 2 - Connect Anchor Line Blue Carabiners To Bottom Grommets

There are two grommets on opposing sides of the bottom of the float. Connect the two blue carabiners to the two grommets. Make sure the clasp lock on the carabiners is securely closed. You don't want your music and beers floating out to sea.

Step 3 - Fill Anchor Bag w-Sand

Step 4 - Roll To Seal Closed

Press out any air in the bag and roll 3-4 times to seal the bag. You can add a few extra drinks in this bag but will need the sand to weigh it down. Carbonated drinks like beer will float so you'll need at least the bottom half of the bag to be filled with sand.

Step 5 - Clip Anchor Bag Ends Together

Step 6 - Connect Anchor Line Black Carabiner To The Anchor Bag

Connect anchor line black carabiner to one of the plastic rings on the anchor bag. Make sure the clasp lock on the carabiner is securely closed. You don't want your music and beers floating out to sea.

Step 7 - Secure The Wireless Speaker To One Grommet

Securely connect the speaker carabiner to one of the grommets in the center speaker compartment and rest it on the mesh floor. You can power up your speaker before of after it's connected to the grommet.

Step 8 - Connect Waterproof Phone Case To Any Grouper Side Grommet

The waterproof phone case can be connected to any of the side grommets using the carabiner. Make sure it is securely attached to the gromet. The phone and case will hang partially in the water and keep it cool from overheating in the hot sun and going into high temp. shut off mode.

Step 9 - Carry Grouper Kit Into The Water

Carry the Grouper float into the water while carrying the anchor bag separately. NEVER PULL THE GROUPER FLOAT AND DRAG THE ANCHOR BAG CONNECTED TO THE FLOAT. IT WILL DAMAGE THE FLOAT.